An undramatic reading of the manual for a bootleg SQ11 clone camera (non-functioning)

Duration: 11:37 1339 transcript words EN summary

Video summary

The video presents a detailed, undramatic reading of the operating manual for a bootleg SQ11 clone camera, which is noted to be non-functioning despite the instructions provided. The guide begins by explaining the charging process for the built-in rechargeable lithium battery, detailing how users can charge the device via a computer's USB port, an external 5-volt charger, or a mobile power bank. It specifies that a flashing red light indicates the battery is still charging, while a solid red light signifies it is full; however, the manual advises continuing to charge for an additional thirty minutes after the light turns solid to ensure the battery reaches 100% capacity. The text also warns about automatic shutdown mechanisms triggered by low battery levels or a full memory card, where the device will save files and power off after flashing red and blue lights for five seconds. The manual outlines various operational modes, including video recording at 720p and 1080p resolutions, photo capture with 12 million pixels, and infrared night vision. Users are instructed on how to switch between these modes using the mode button, observing specific light patterns such as a long blue light for standby or flashing red and blue lights for active recording. The device features motion detection capabilities that automatically record moving objects for five-minute cycles before saving and stopping, with separate settings available for both 720p and 1080p video qualities. Additionally, the guide explains how to enable infrared night vision by holding the power button for two seconds and describes the automatic shutdown timer that activates after one minute of inactivity if no functions are being used. Connectivity and data management are addressed through instructions on using the USB cable to connect the camera to a computer or TV for data transfer and screen display. The manual notes that while the device can function as a U disk once connected, users may encounter issues if the computer does not recognize the removable drive within thirty seconds, in which case a reset via a sharp object inserted into a reset hole is recommended. It also mentions that video files saved to the internal memory might play unevenly due to large data volumes and suggests using an SD card reader for smoother playback. Furthermore, the guide explains how to customize file naming formats by editing a text document on the computer to include or exclude time watermarks, with specific examples showing date and time codes followed by either a 'Y' or 'N' suffix. Finally, the summary concludes with important safety warnings and usage precautions emphasized in the manual. Users are advised to operate the camera within natural temperature ranges and suitable humidity levels, avoiding damp environments since the device lacks waterproofing. The text warns against exposing the lens to direct sunlight to prevent damage to optical components and cautions against using the camera in excessively dusty conditions that could impair image quality. Environmental protection is highlighted as a key consideration, with strict prohibitions against throwing the product in fire due to explosion risks or disposing of it improperly. The manual also notes that the device may feel warm during use because of its high current consumption, which is considered normal for this type of HD DV recorder, and reiterates that charging typically takes two to three hours for a complete cycle.

Read the full video transcript

SQ11 Mini DV operating manual operation instruction The machine built-in rechargeable lithium battery first time using this machine, please charge can be charged by the following way. One Connect computer charging the use of USB connect with computer. Two Can charge while recording video can also charge an external USB 5-volt charger or mobile treasure. Three After charging flashing red light, full of red lights long said charge. Red lights, please charge again more than 30 minutes to ensure that battery is 100%. Note When the battery is insufficient, T recorded in the card is full, DV red and blue light will flash for 5 seconds after directly into protection state of shutdown, save the file and automatically shut down. Recording file has been saved. At this time, please charge on this machine. Products without a card, red and blue lights flash for 5 seconds automatically, power off at the same time. No work after boot mode, 1 minute automatic shutdown. USB with TV cable can be inserted into the computer for the machine is charging and data transmission. Can plug in TV out screen display. Can insert DV 5-V charger while external record. 720p video not flash. Click on-off button to boot. Boot blue light normally on. Click on the switch machine. Under the blue light flash three out of 720p video. Video process lamp don't suggest. A segmented automatically save 5 minutes continuous video cycle cover. Click the switch button again to stop video. Back to the blue light normally on standby mode. 1080p video not flash. Boot blue light long on standby mode. Press the mode button. Red and blue lights long for 1080p video mode. Click the switch machine button once again. Blue light out under the red light flashing on the long three. 5 minutes for 1080p video a piecewise continuous recording save automatically. Cycle cover. Click the switch machine again to stop video. Go back to the standby mode. Picture 12 million. On standby mode. Press mode button for two times long red light for picture mode. Then click on buttons flash a red light. Photo one. 12 million pixels automatically saved. Infrared lamp. Open. Boot any standby mode. Press and hold the on-off two seconds under the red light flash two infrared night vision lamp open. Can see video. Close. Infrared night vision light no standby mode. Press and hold the on-off two seconds. The red light flash three to shut down the infrared night vision under the lamp. 720p motion detecting. In blue light standby mode, press mode key for 3 seconds, red light flashing on the long three under blue lights open motion detecting video mode. Both of detected objects move after red and blue lights flash for 720p mobile video at the same time, a period of 5 minutes. Automatic packaging to save, don't cover, cycle cover. There is no moving objects standby all the time without electricity or T card record. Click on any button, one exit motion detecting mode. 1080p motion detecting. In the red and blue lights normally on 1080p video mode, long press the mode button for 3 seconds flash three red, blue lights flash three after a long bright red into the open mobile video mode. Both have to detect moving object, red and blue lights flash for 1080p mobile video at the same time, a period of 5 minutes. Automatic packaging to save, don't cover, cycle cover. Without moving objects standby until electricity or T card record so far. Click on any button once launched motion detecting mode. Filling record. Insert the T card. External insert USB TV line, the external USB 5-V power supply or charging treasure machines directly into 720p video mode. No manual stop has been recorded at the card with or without power, can also be manually stop video switch any mode. Connect USB TV line, the boot after TV video can see through the TV screen images. This can take photos and videos motion detecting use. Machine crashes, buttons can't normal use. Can use a sharp object to reset reset hole insert to the machine. Can use normally after reset. In the stop video pictures motion detecting function mode, the need to shut down long press on off button for 6 seconds or so. See the red and blue light to turn it off. Or in standby mode without using any power function can standby for 1 minute automatic shutdown. The machine will automatically create a txt document in the TF directory Kagan pictured. Shutdown data line connected to the computer on a removable disk to open the time rest.txt text document. Edit the required time such as format the date when save text files after 2016 0804 174726. Y boot record video can be saved file. It will display the video editing time. Does not require time watermark is the same mode of operation. Mainly, the difference between tail of the letter Y and N. Refer to the following format. 2015 0608 192526 Y time watermark display. 2015 0608 192526 N no time watermark display. Notice. Please be sure to confirm the product has been inserted in the T flash micro SD card. In the absence of card products, double flashing red and blue lights can't normal use. Please insufficient lighting conditions is taken by the camera to like and subject to keep a distance of more than 50 cm. This will correct the color is natural, the scenery is clear, the stability of the images. On standby and off can be connected directly to the computer. Connect the computer after can be used as a U disk, files are free to copy and paste, delete, format the U disk. Insert the machine into the computer USB port, the computer will pop up a few seconds after removable disk logo. The blue indicator to identify USB device can carry out data transmission. The red indicator for charging, the red light is full off. Reminder. After the machine to connect the computer, if the computer can't identify or still did not pop up in 30 seconds removable disk logo, please reset to plug again. Suggest using the T card reader directly read the video files to play and play directly by USB connection in the video file. In this video recorder built-in memory, maybe because the data volume is too big, transport couldn't keep up with the play not smooth. Note. After each use of the battery recharging, it takes about 2 to 3 hours or so to completely filled with filling. Each full red and blue lights 30 minutes again, as far as possible after the battery full use. Because of this product is a real HD high DV, product consumption current is bigger than general, please use zinc alloy shell material and when using the product may have some hot state belongs to the normal phenomenon. Don't have to worry about bad products appear. It's a long time after aging test to ensure the product quality problems before shipment. Matters needing attention. Use occasions. Please strictly abide by the relevant national laws and the product may not be used for any illegal purpose. Otherwise, the consequence is proud. Working temperature. Please use under natural temperature. Do not work in the human body cannot adapt to the temperature. Working humidity. Please use under suitable for human living environment humidity. Please do not put product in a damp working environment. The product does not have waterproof function. Please keep this product pour water or exposed to rain water. Shooting illumination. Please have adequate light source under the environment of use. Do not use such a super light source camera directly into the sun to avoid optical devices damaged. Cleaning. Do not use an excessive dust density environment in order to avoid the lens and other components from dust impact camera effect. Waste treatment. Please pay attention to environmental protection. Do not throw this product. Forbid throwing this product in the fire so as to avoid explosion. >> Hey.